size 2 MB  / 6 MB

LV-60 is an analog graphic equalizer.

• 10 filter bands with 12 dB of negative and positive gain.
• Low-shelf, high-shelf and 8 peak notches with two having the option to be shelves or bell shapes by toggling the bell buttons below the filters.
• Analog-inspired saturation circuit. When the drive is set to 0, the drive is bypassed, any values higher than 0 engage the saturation circuit.
• Proportional Q controlled by the gain of each filter. Gain values above 0 gradually thin the Q value. The negative end of the gain range has a much thinner Q than the positive end, so it’s great for cutting unwanted frequencies.
• Trim knob to control the overall volume of the plugin.
• Fully DAW-compatible automation parameters for each control.
• Toggle button to turn off shadows. This helps under-powered laptops that lag when using the user interface.

https://www.patreon.com/ViatorDSP

LV60_Win  ( 2 MB )

LV60_Mac  ( 6 MB )

size 25 MB  / 3 MB

Viator Reverb is a room reverb unit.

https://www.patreon.com/ViatorDSP

ViatorDSP-Reverb_Win  ( 3 MB )

ViatorDSP-Reverb_Mac  ( 25 MB )

size 3 MB  / 26 MB

Diode Amplifier is a tube guitar amp.

https://www.patreon.com/ViatorDSP

ViatorDSP-DiodeAmplifier_Win  ( 3 MB )

ViatorDSP-DiodeAmplifier_Mac  ( 26 MB )

size 6 MB  / 11 MB  / 11 MB 

LV-50A is an analog equalizer.

It combines the sound and curves of two different hardware EQ’s that have defined music studios across the decades. This EQ is inspired by real EQ’s, but it definitely has its own flavor.

• Oversampling of 8x when oversampling is turned on from the top-right dropdown menu. This makes a huge difference on the top end frequencies.
• Four EQ bands with proportional Q and 12 dB of boost and attenuation.
• When the gain of a band is set to 0 dB, the filter circuit disables, which saves loads of CPU if you aren’t using the band anyway.
• Saturation algorithm on the output, the EQ pushes into it. When the drive is set to 0 dB, the circuit disables to save on CPU.
• The low and high bands can be a shelf or bell depending on the state of the button under each band.
• Reset button to set all band’s gains to 0 dB.
• High and low pass filters to filter out the very top and bottom frequencies that aren’t super useful. Toggle the filters button under the drive. These filters really make a huge difference when oversampling is on.
• Phase inversion button to flip the phase of the entire circuit. This is useful for parallel processing.
• Trim gain to boost or attenuate the volume of the entire plugin.

https://www.patreon.com/ViatorDSP

LV-50A_Win  ( 6 MB )

LV50A_MacVST  ( 11 MB )

LV50A_MacAU  ( 11 MB )