TAL-NoiseMaker is an improved version of TAL-Elek7ro and has a completely new synth engine and a lot of improvements in sound and usability.
The synth also includes a small effect section with a reverb, chorus and a simple bit crusher effect. A display shows the knob and slider values. This allows more control over the synth. A ringmodulator and a syncable triangle are also part of this synth. TAL-NoiseMaker includes new filter types as the self resonating 6dB low pass and a notch filter. Its improved amplitude ADSR is very suitable for slow pads as for really fast envelopes. 128 factory presets included, 80 made by Frank “Xenox” Neumann / Particular – Sound.

• Osc 1, +- 24 semitones, fine tune, phase control (saw, pulse, noise).
• Osc 2, +- 24 semitones, fine tune, phase control (saw, rectangle, triangle, sine).
• Sub Osc (rectangle).
• Osc 1 PM for pulse waveform.
• Osc 2 FM controled by Osc 1.
• Osc 1 & Osc 2 sync to sub osc (saw, pulse, rectangle, triangle(bipolar sync)).
• Adjustable master tune and transpose.
• Up to 6 voices.
• Portamento in mono and poly mode (off, auto, on).
• Ringmod modulates Osc 1 with Osc 2
• Self resonating 4x oversampled filters (24 dB LP, 18 dB LP, 12 dB LP, 6 dB LP, 12 dB HP, 12 dB BP, Notch).
• Volume and Filter ADSR (negative and positive).
• Routable ADSR, modulates Filter, Osc 1, Osc 2, PW, FM (negative and positive).
• 2 LFO’s with different running modes: free, sync to host, triggered by note.
• Modulates filter, osc 1, osc 2, fm, pw, lfo rate, panorama and volume.
• Sine, triangle, saw square, s&h, noise.
• Positive and negative modulation.
• Phase control.
• Adjustable Velocity dependent control over volume filtercontour and cutoff.
• Adjustable Pitch Wheel control over Cutoff and Pitch.
• One pole HP filter.
• Detune, detunes notes randomly.
• Juno chorus with different modes.
• Built-in reverb and delay.
• Adjustable filter drive.
• Bitcrusher, affects osc 1 and osc 2. Its a pre the filter stage effect.
• Midi learn for all knobs.
• Panic button.
• 256 great presets.

https://tal-software.com/

TAL-NoiseMaker  ( 1.95 MB )

TAL-NoiseMaker-x64  ( 1.35 MB )

TAL-NoiseMaker_MacAU  ( 2.75 MB )

TAL-NoiseMaker.vst_  ( 2.66 MB )